For coated-steel sheet products, the standards are written by ASTM Committee A05, a body obtain a copy of the appropriate ASTM Standard. A /A M. ASTM AAM 薄镀层电解镀锌薄钢板 – Designation: A /A M – 98 AMERICAN SOCIETY FOR TESTING AND M. Find the most up-to-date version of ASTM A at Engineering
|Published (Last):||27 June 2017|
|PDF File Size:||14.70 Mb|
|ePub File Size:||12.24 Mb|
|Price:||Free* [*Free Regsitration Required]|
A number in parentheses indicates the year of last reapproval.
A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense.
This product is available in four zinc-coating designations which are listed in Table 1. For electrolytic zinc-coated steel sheet with coating masses heavier than described in this speci? The coating is used to provide some enhancement in corrosion performance as compared to an uncoated product. It is not intended to withstand outdoor exposure without chemical treating and painting.
Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.
ASTM A591 EDDS galvanized steel coils & sheets
Current edition approved May 10, Originally published as A — Last previous edition A — The thickness is the total of the base metal and the coating. NOTE 1—A typical ordering description in inch-pound units is as follows: A typical ordering description in SI units is as follows: If one surface is protected suitably during the initial stripping, coating mass can be determined for each surface independently.
Conversion of the coating mass to coating thickness is possible only if the density of the coating is known precisely. This method is readily adaptable to the continuous monitoring of coating mass during coating. Thus modern electroplating facilities are frequently equipped with X-ray?
These devices are permitted for use as a basis for determining suitability for shipment provided that they have been calibrated properly. The method is rapid and versatile for light coating mass applications. Flaking of the coating within 1? Flaking of coating within 1? The ratio of the bend diameter to the thickness of the specimen for Structural steel shall be as outlined in the Bend Test Requirements table of Speci?
The specimen shall be cut not less than 2 in. Dimensions and Permissible Variations 7.
ASTM A EDDS galvanized steel coils & sheets
Notwithstanding the absence of a signature, the organization submitting the documents is responsible for the accuracy of the information. Packaging and Package Marking 9. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.